Uso un multímetro para medir el voltaje de el cero y tierra cables
What will happen if the zero wire and ground wire are connected in reverse? Is the zero wire and ground wire connected? What is the voltage between the zero wire and ground wire in volts? Related technical articles: Use a multimeter to measure the voltage of 220V between the zero wire and ground wire
In the TN-S power supply system, the zero line and ground wire are both of the same origin and are led out from the neutral grounding of the transformer. One participates in the working circuit and is called the working zero line, while the other serves as the protection circuit and is called the protective zero line.
If a multimeter is used to measure the voltage of 220V on the zero and ground wires, based on my judgment, there may be the following reasons:
1. El neutral y vivo cables es es conectados en in reverse
Si esto situación ocurre, it puede ser debido a desordenado cableado, falta de color diferenciación en los cables, o el terco creencia que izquierda cero y derecha fuego are causando ello.
The handling method is also simple. Since you have a mulmeter at hand, use a mulmeter to measure the three values separate
La resistencia y voltaje entre los tres cables debería ser redefinido , incluyendo que es el vivo cable, que es el suelo cable. Marcar ellos correctamente así que usted won't hacer cualquier errores siguiente tiempo.
2. There is a breakpoint on the zero line
Es mejor para medir el voltaje en la potencia circuito interruptor , y si conveniente , en el medidor. si medido en el backend del dispositivo 2c allí es una posibilidad de cero línea rotura y error de juicio.
The back end zero line is broken, and at this point, the live line and zero line will be connected through the filament or coil. Alwhile there may be some resistance, it can be basically ignored, and the measured voltage change is not significant. In this situation, it is necessary to remove electrical appliances such as light bulbs, disconnect the circuit of the zero and live wires, and La medición será precisa.
3. El cero línea resistencia es demasiado alto
Esta situación es básicamente causada por suelto engarzado y pobre contacto. Sin embargo, el voltaje medido en esta situación es errático, y allí puede ser calentamiento y escaldado fenómenos en las esquinas de los cables.
4. El equipo carcasa es vivo
Si el equipo carcasa es electrificado, que significa que el vivo cable es fugas, y an ordinario aire interruptor es usado, el fuga corriente no alcanzar el cortocircuito corriente, y el aire interruptor no viaje. en este caso, medidor el cero y tierra cables may result en a voltaje de 220V.
Alternativamente, although a leakage protector is used, the ground wire is disconnected or the ground resistance is too high. In this case, leakage happens, and there will also be 220V voltage measured on the zero and ground wires.
