Cómo para Calibrar a Polarizar Microscopio% 27s Polarizador
En real operación / 2c la vibración direcciones de el superior y inferior polarizadores de el polarizador microscopio debe ser orto cada uno otro, o el este-oeste o norte -sur direcciones , respectivamente consistente con el horizontal y vertical direcciones de el ocular retícula. A veces solo uno inferior polarizador se usa para la observación, vibración dirección de polarizador debe debe determinar , así el polarizador debe ser Corregido durante operación.
1. Detection of eyepiece reticle
It is necesario to check si la retícula de el ocular es ortogonal y si it es consistente con la vibración dirección de los polarizadores superior y inferior . At the same time, choose a piece of biotite that has been fully cleaved, move it to the center of the eyepiece crosshair, and make the cleavage seam parallel to a thread of the crosshair, record the scale number of the stage, and then turn the stage to make the cleavage seam parallel to for the other crosshair, record the scale number of the objective stage, the difference entre el dos escala números es 90 grado , indicando eso el punto de mira es ortogonal.
2. Determinación y corrección de la vibración dirección de el inferior polarizador
El uso de biotita a comprobar la vibración dirección de el polarizador es porque biotita es a ampliamente distribuida transparente mineral que es muy característica bajo simple polarizada luz. Primero encontrar una pieza de biotita que es escindido y claro, moverlo a el centro de la retícula de el ocular, empujar salir el superior polarizador, rotar la etapa para una semana, y observar el color cambio de biotita, porque biotita tiene la más fuerte absorción de vibración luz en la dirección de escisión , so cuando el color de biotita alcanza el más profundo, la dirección de el escisión costura es la vibración dirección de la inferior polarizador.
3. Ortogonal corrección de el superior y inferior polarizadores
After the direction of the lower polarizer is calibrated, remove the sheet, push the upper polarizer in, and observe si el field of view is fully black, that is, whether it is in an extinction state. If it is completely black, it means that the vibration directions of the upper and lower polarized lights are orthogonal to each other. Else, the upper polarizer must be corrected, that es, turning the upper polarizer to make the field of view reach the darkest. when turning, the stop screw of the upper polarizer must be loosened first, and then tightened after calibration.
